Results 1 to 4 of 4

Thread: Problem with minimums start level in links

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1

    Problem with minimums start level in links

    Hi everybody,

    I would like to modelize specific configuration during strict dry water flow. At the beginning of the simulation, there is no inflow but water level is about 10 cm. I can not manage to decrease it in spite of changing minimum level in links parameters.

    In other 1D modeling software, lower slots can be activated in order to minimize water flow provided by the minimum level urged by the model. Is it possible with Infoworks ICM? Other solution?

    Thank you by advance

  2. #2
    Senior Member
    Join Date
    Feb 2013
    Posts
    125
    Have you changed both minimum base flow and base flow factor in simulation parameters?

  3. #3
    No, I have not changed minimum base flow and base flow factor in simulation parameters.

  4. #4
    Senior Member
    Join Date
    Feb 2013
    Posts
    125
    That is what you need to do, then. Model- model parameters - simulation parameters - top two lines. Help is very clear on how this works. Try reducing one at a time until you get the results you need. This may, however, reduce stability, so don't over-do it.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •