Search:

Type: Posts; User: DObolevics

Search: Search took 0.01 seconds.

  1. Hi Duncan, Thanks a lot for your reply. The...

    Hi Duncan,

    Thanks a lot for your reply. The area that is covered by 2D zone is quite extensive, according to ICM it is 32422 ha.
    I have used the following parameters for 2D zone: Max triangle...
  2. 2D mesh in ICM - the best minimum element size

    Hi,

    Small elements within 2D mesh slow down the simulation. I have reviewed elements within 2D mesh and simplified geometry of some of voids-polygons to remove all elements that have area of less...
  3. Replies
    0
    Views
    3,608

    RTC file for pumping station

    Hi,

    Is there a way to add the command for the pump in the RTC file that will do the following:

    "If level at the us node of the pump is XXmAOD and level at the ds node of the pump is YYmAOD,...
  4. Replies
    4
    Views
    6,460

    Paul, Thanks for your reply. I need to use an...

    Paul,

    Thanks for your reply. I need to use an RTC file for my solution anyway, so I just amended it and set up the rule that pump does not go on. It seems to work.

    Thanks.
  5. Replies
    4
    Views
    6,460

    Nicole, Thanks for your reply. I am using...

    Nicole,

    Thanks for your reply. I am using InforWorks CS 12.5. This is actually what I have done, just amended the RTC file that pump never goes on. I just wanted to check, if there is any other...
  6. Replies
    4
    Views
    6,460

    Failure mode of the storage tank

    Hi,

    How would you model a failure mode of the storage tank?
    To replicate a situation when pump fails to operate?

    Thanks
Results 1 to 6 of 6