PDA

View Full Version : InfoWater - Flow issue



Mmajner
November 15, 2016, 03:54 PM
I was checking pipe flows and came across an odd situation. I have a run of pipe that has 700 gpm (Orange) of flow hits a valve that is open with no controls on it and then all of a sudden goes down to 350 gpm (Yellow) until it hits the next node on the line and then goes back up to 700 gpm (Orange). What may be the reason that it would be doing this? There is no demand in this area either.

348

Patrick Moore
November 18, 2016, 01:11 PM
Martin,

It may be easiest to contact us at support@innovyze.com to look at your model together to resolve.

You should also verify that there are no duplicate overlapping pipes in the area where flows seem to be disappearing to eliminate that as a possibility.

Patrick Moore