PDA

View Full Version : View results during last hour of run time



D_Prasanna
November 2, 2015, 01:17 PM
How do I view the results during the final hour of run time before it failed? The run failed at 5:00:00.. I can only few results till 4:00:00 although in the report it is mentioned that available run result duration is 4:54:22 hrs.

Thank you.

Patrick Moore
November 3, 2015, 07:46 AM
Devi,

Thank you for posting your question. Results are posted by the model based on the Report Timestep specified in the run manager under the time setting option. Based on what you are describing and because the default option for this setting in the run manager is one hour, this is likely what your model is set to use. This means that results are written at the top of every hour and since your model crashed at 4:52 hours, the last results written are at 4:00.

If you wish to see more output results before the model crashes, simply lower the report timestep setting to a value smaller than one hour to see more results. For instance if you lower the value to 15 minutes, you can see results up to 4:45 in the simulation. See below for where to find the Report timestep used for this run so you can change it.

How to change the report timestep in the run manager:
(Click for a larger image if necessary)

179

Innovyze Support

D_Prasanna
November 5, 2015, 10:41 AM
Thank you so much for the quick response.

Devi

Patrick Moore
November 5, 2015, 10:42 AM
Devi,

You are very welcome! Glad to be of assistance.

Innovyze Support