View Full Version : InfoWater Default Units

June 10, 2015, 12:03 PM
How do you change the default units in InfoWater? I am trying to change the pipe size units to no avail.

Patrick Moore
June 12, 2015, 03:59 PM
Hello Dean,

Default units for InfoWater are changed in the output unit manager found in the InfoWater-> Tools-> Output Unit Manager menu. I

t will pop up the following window: (click on the image for a larger view)

If you wish to reset the units to default SI or US units, just select the appropriate button in the Default units area and they will reset.

Incidentally, the units used in the simulation are set in the simulation options selected as one of the options in the run manager. They are changed in the General tab and are highlighted in the image below. This changes the units for Flow and pressure shown in the output reports and used in the simulation itself.

See below: (click on the image for a larger view)

If you have further issues, please feel free to contact us at Innovyze support as well by emailing questions to support@innovyze.com .

Patrick Moore
Innovyze Support