PDA

View Full Version : Infowater calibrator



m2india_saurabh
April 22, 2015, 12:12 PM
I want to plot the junction pressure using the junction from the model (simulated vs observed ) in EPS mode using the infowater calibrator but unable to proceed with the error 7111: no vaild calibration element.
I would appreciate if someone can please try to resolve this issue ASAP?


104

Best Regards,
Saurabh

Shawn Huang
April 29, 2015, 09:11 PM
Did you enter observed data in junction pressure tab? I think you can use Report Manager's graph to bring in observed data for comparison.
If you want to send the model, please use support@innovyze.com.


I want to plot the junction pressure using the junction from the model (simulated vs observed ) in EPS mode using the infowater calibrator but unable to proceed with the error 7111: no vaild calibration element.
I would appreciate if someone can please try to resolve this issue ASAP?


104

Best Regards,
Saurabh