View Full Version : Simulating an inflow onto surface

April 28, 2014, 09:58 AM
Hello, I am trying to model a river's outflow from a storm onto the surface of my model. I have the peak flow known and am modelling that as an inflow event at a point. Upon running the simulation onto my 2D mesh, it does not load any inflow and there is certainly no surface water. I have checked that the inflow event and point name match and that the inflow event is checked under the simulation parameters.

Could anyone offer any incite? Regards, Andrew.

Kristian Ravnkilde
May 8, 2014, 09:25 AM
Is your poitn a 2D point source? It needs to be.